PDA

View Full Version : Conform to curves



Omto
03-04-2003, 08:24 PM
I have been trying to make a curvey pipe thing....I tried Eugeny's tut on it but I didn't like the stretching I was getting...

Here i my pipe

Pipe (http://users.adelphia.net/~omto1/Pipe.htm)

I made a curve for it and brought it into layout and used conformcurve....and for this..

Pipe2 (http://users.adelphia.net/~omto1/Pipe1.htm)

I am wondering if there is a better way...possible all in modeler to accomplish this with a little more control??

Thanks for any help.

faulknermano
03-04-2003, 10:00 PM
look for the tool called spline guide. open up its numeric and under OPERATION, select BEND.

experiment on this.. i think it will get you where you want to go.

Omto
03-05-2003, 10:41 AM
Perfect! Thank you.