PDA

View Full Version : Scale and rotate tool no longer centered at cursor



aSkeptic
09-20-2013, 06:33 AM
Hello everyone,

Since I've installed LWCAD whenever I try to scale or rotate it centers my action at the Modeler's origin and not where my cursor goes. Is there anything I can do to get it back to its original behavior? Its really affecting my productivity.

Danner
09-20-2013, 06:58 AM
it's not LWCAD you changed the action center. There are 4 action center options: "mouse" "selectioin" "pivot" and "origin" There should be buttons to change them at the bottom in modeler or press shift F5, shift F6, shift F7, shift F8 to change it.

aSkeptic
09-20-2013, 07:15 AM
it's not LWCAD you changed the action center. There are 4 action center options: "mouse" "selectioin" "pivot" and "origin" There should be buttons to change them at the bottom in modeler or press shift F5, shift F6, shift F7, shift F8 to change it.

Thank you so much!

tburbage
09-23-2013, 05:44 PM
Well, and note LWCad tools pay no attention whatsoever to the LWM Action Center controls. LWCad has its own coordinate system controls (UCS) that work in conjunction with the Snap settings.