PDA

View Full Version : Need Advice please



Tony3d
03-03-2013, 11:06 AM
Can someone explain to me why this is happening when I twist this tube? Can't see why this should happen I beveled the front, and back to bridge it to form the hole. Rounded the edge, and twisted it. Can't figure out whats going on here.

Tony3d
03-03-2013, 11:10 AM
Figured it out. I was segmenting it as I made the tube, then bridged it which made the inside one segment. I'm stupid!

Snosrap
03-03-2013, 11:47 AM
Wow that's a lot of polys!

Tony3d
03-03-2013, 11:55 AM
Yes, just hit a new 3.06 Mac Pro 12 core, and been having fun.