View Full Version : Corruption of Config File?

02-17-2013, 10:01 AM
After causing a crash on Modeler 11.5 by pressing the 'o' when I had no geometry, I now see that the four "buttons" that I am used to being labelled as "Points ^G", "Edges" and Polygons ^H" have been replaced with buttons "AC:Mouse +F5", "AC:Selection +F8","AC"Pivot +F7" and "AC:Origin +F6" respectively. Is this because a config file was corrupted from the crash or is this some strange new feature of Modeler 11.5 that I just now noticed? How do I get it back to normal?

02-17-2013, 01:51 PM
This is how modeler is now in 11.5. There is no corruption of your files. You will find the same options for selection mode in the left menu now. Not sure if the older preset options will reset it to the way you are familiar with. I usually just cylce through selection modes using the space bar anyway.