PDA

View Full Version : A The Nissan 350z tutorial (hang UP)



gepp24
11-02-2003, 10:58 PM
Hello All,

If someone can help me on this question, I might have hair left by the end of the week.

I am not far in the 350z car tutorial, and not far i mean page 2 ch 1. On the bottom he says to weld 2 sets of points, and then make poly command on a group of three. Well I get a crapy looking triangle. I select them clockwise and in the 1,2,3 fason, and it will not conform to the rest of the fender section.

Anyone that has run thru this lesson and can point me in the right direction, I would love to hear from you.

Link is below

and a pic of my triangle problem

http://www.newtek.com/products/lightwave/tutorials/modeling/car/index2.html


Thanks

;-J

Beamtracer
11-02-2003, 11:08 PM
That triangle doesn't look like it's subpatched.

Select the triangle only by clicking on it (don't select any other polygons). Then hit the tab key to subpatch it.

gepp24
11-03-2003, 07:09 AM
Thanks I new it was something stupid. Now I can stop pull my hair out.

-j