PDA

View Full Version : GoZ problems



NinoK
08-16-2012, 10:35 AM
So I made an object in LW to get general proportions and then sent the object to Zbrush via GoZ. Made some tweaks and sent it back. All seemed well. I then crated a subtool in zbrush to try something but then ended up deleting it. I saved the tool again but when I tried to send it to modeler it sends an empty layer, and a simple cube in another.

Any idea what's going on? Now even if I close both programs, open zbrush fresh load that tool and hit goZ, it always sends a box to modeler.

NinoK
08-16-2012, 12:05 PM
Ok, so I chose to have Zbrush send it to layout instead and it worked fine. I then reverted back to sending it to Modeler and now modeler works fine as well. Wondering if some temp file was writing somewhere.

Anyway, problem solved :p.