PDA

View Full Version : Overlapping Polys?



objuan
05-31-2012, 07:51 PM
I have some polys which are welds on a giant cylinder. In the end we will be focusing on the welds, so they are modeled geometry and bulge out a little, like 5mm from the cylinder wall.

Up close everything renders fine, but if I pull the camera back often times the cylinder renders over the weld in a rather sporadic fashion. See the attached image.

I tried super high antialiasing and it makes no difference.

How do I get LW to render the thing how it is built?

lwanmtr
06-01-2012, 03:10 AM
Try increasing the geometry on the big tower thing. segments and slices, that way there is enough normals for lw to know what to render over what

Danner
06-01-2012, 08:19 AM
What version of LW are you using? Which camera type? What are your antialias settings?

objuan
06-01-2012, 10:19 AM
'Enhanced Antialiasing' seems to have done the trick. I hope.

Weird because Extreme Antialiasing still has the issue, even when I increased the pole geometry, but even Enhanced Low seems pretty good.

Thanks guys.

lwanmtr
06-01-2012, 02:04 PM
cool