PDA

View Full Version : little problem with the vertex points



crusader
10-24-2003, 05:58 AM
I think this problem is described in some threads and I searched for them, but I could`t find one.

I made a model of a tank.
And after moving and modifying the right side of the tank isn`t any longer parallel to the left side.

Is there an option to select the vertex of one side and bring them all on the same position of the x- y- or z-achse.

Maybe it works with the move tool + numeric panel, but I don`t really understand the numeric p. for movements.

Please, can somebody wright a short answer ?
(sorry for my bad english)

peteb
10-24-2003, 06:05 AM
If it's a problem with the points on just one side, so all the points on one side of the X or Z are out? Then the way I'd do it would be to just region select all those points and then in one of the orthographic views (depends what way the tanks mirrored) I'd just line them up by eye, just make sure you zoom in real close.

Dodgy
10-24-2003, 10:58 AM
You should have had Symmetry on.

But you could cut your tank down the middle (using the knife tool) and then delete one side and mirror the other to make them match...