View Full Version : question on mask

10-21-2011, 08:53 AM
This question was brought up not that long back and I could not find the post.

Is there a way to place a video onto a cube object ? And also can you have more than 2 videos at the same time on 2 cubes?

I was looking over MASK in the manual but looks like a single photo mask. I am looking at a few seconds of video on each object.:lwicon:

10-21-2011, 09:30 AM
Just assign a surface to where you want your videos, say one face on one cube, one face on the other. Go into the color channel of each surface and assign a video as the image map, and you're done.

Example of what happens: http://screencast.com/t/yvqwtu3mTpdA

If this is what you are looking for. I apologize for the quality, LightWave was referencing two videos and Jing was recording as well as the virus scanner running for some reason, so on my end this looks better than the vid, when all of that isn't going on :)