View Full Version : NO Video Signal - Possible Driver Lockup

10-13-2003, 08:05 AM
I just installed my VT3 on a new system

Asus PCDLU - dual xeon 2.8
1gb Ram
Adaptec 3940

I am running Xp with SP1 and all updates.

When I launch VT3 software and try to load up a VT-Vision. I get the error No Video Signal- Possible Driver Lock up.

I currently dont have sources attached to the back of the card.

I took the card to a much slower P4 system and it seems to work with out any connections, but much slower.

Does anyone have any sugestions?



11-10-2003, 02:22 AM
I have had the same problem then i uninstalled VT[3] and reinstalled it worked fine for few hours then it hung and wouldnt switch back on again.

I went back to vt2 for the timebeing till we finish our project then try vt3 again

11-10-2003, 02:29 AM
Did you do a full wipe/reformat install of T3? or uninstall T2 then install T3?

Try searching this forum and maybe this one
for 'possible driver' or etc. Its discussed much, but solutions are slipping me.


11-10-2003, 02:43 AM
I did an vt[2] uninstall and then reinstall vt[3] i think i need to do a clean wipe and then install vt[3]

Thanks, will check the toasternt forums.