PDA

View Full Version : Lightwave 10 fails to load colour tables?



akademus
08-10-2011, 11:54 PM
All of the sudden LW wont seem to load colour tables. When I start it it gives the error message asking to load colour table (which I have no clue where it is) and then loads in funky new design :)

Anyone has this happened???

Thanks

prometheus
08-14-2011, 01:20 PM
All of the sudden LW wont seem to load colour tables. When I start it it gives the error message asking to load colour table (which I have no clue where it is) and then loads in funky new design :)

Anyone has this happened???

Thanks


You mean that your UI becomes screwed up..and it canīt find the color tables?

That is most likely due to you trying to work with both lw10.0 and 10.1
without closing one of them first and not closing the hub aswell.
that will screw up the config files unfortunatly.
To bad Newtek couldnīt deal with this and provide a good way to work with lw10 an 10.1

Even if I close the hub and close the 10.0 version...and start lw 10.1 and then close that and the hub and goes back to the 10.0 version..I still can get screwed up UI...because of this color space mess:mad:

Michael