PDA

View Full Version : Right-Side Rig Failure?



rcallicotte
04-23-2011, 02:43 PM
Please see the attachment, but if you think you have even a remote idea why I see this I appreciate it already.

The LWO is clean. I've even remade it to make sure. The rig on the left side works fine, but the apparently similar right side has this issue. It's very strange - I've even compared all my settings on the left with the right, etc.

But, I'm listening. I have no idea what's going on.

shrox
04-23-2011, 02:50 PM
From the picture it looks like extra geometry. Did you try "merge points" in modeler using "fixed" and some bit of a distance value?

And are you using weight maps?

rcallicotte
04-23-2011, 03:16 PM
I used merge points on two points only. I agree it looks like geometry. I just checked and I see no duplicate geometry and no hidden layers.

Yes, I'm using Weight Maps and checked these for the RightThigh and RightCalf. These are chosen in my Bones properties in Layout.

rcallicotte
04-24-2011, 04:14 PM
Just changed the mesh out and this was fixed.

Funny, since I checked the layers for extra geometry, checked the weight maps (and recreated) and looked for merged points or duplicate polys. No luck and no time to keep searching.