View Full Version : Loop selection problem

02-10-2011, 01:16 PM
Hi guys!
This is a simple one.
Please look at the pictures attached.
I selected on of the polygons (pic1) then I tried using loop selection in LW but I simply cannot get the result that I want in pic2.
Why cannot I select this loop?



02-10-2011, 01:30 PM
To properly select a loop in poly mode you should have two polygons selected to help LW know what direction you want to go in. You can have one selected but it's a gamble which way LW will select. Same applies to point loops.

Also, depending on how the object was created/edited, LW may not see that as a loop anymore.