PDA

View Full Version : Modeler Not Saving



JBT27
07-02-2010, 12:00 PM
We've got a problem where hitting 's' to save an object in Modeler, after some adjustment, then closing and reopening the file, shows no change to the object, ie. the adjustment we made isn't there, the object is as it was beforehand.

This keeps happening. Any ideas why this might happen, or anyone had this before?

Thanks.

Julian.

zapper1998
07-02-2010, 12:04 PM
You Have to feed a few quarters, in the little coin slot on the back of the Computer.....


hehehe


Check your Keyboard Short cuts...
I usually use the Production Style..

The Alt+F9 get you there..

JBT27
07-02-2010, 12:45 PM
Haha :D ..... I knew there was something fundamentally wrong!

The keyboard shortcut is set to 's' - same as on my license that is working OK. But the other license, set up the same way, is sometimes saving, sometimes not.

Unless the keyboard itself has gone flaky ..... rendering now - will check later, but not convinced that's it, as there is no problem typing the letter 's'.

Julian.