PDA

View Full Version : Part Surface node? (Akin to DPkit 'Part Move' node



AbstractTech3D
04-21-2010, 09:32 AM
Hi There

I have some 3d text that I've animated using the DPKit displacement 'Part Move' node, which derives an ID for each individual letter (all located on a single layer) using the 'Part info' node (also under displacement). Thus each letter can be separately controlled.

However, I also wish to colour each letter separately. I was hoping to use the same trick in the surface editor: node editor. However, there is no 'Part surface' type node that I'm aware of... ? As far as the surface editor is concerned, it seems to think each polygon corresponds to a separate part when using 'part info'.

Since I intend to animate a large number of these text elements, I really hope to find a relatively automated way to achieve this.

Any thoughts?

pyo
04-21-2010, 09:50 AM
Connecting 'index' output from PartInfo into gradient input indeed behaves strange but if You use 'index' from PartMove it works as it should.

AbstractTech3D
04-21-2010, 10:00 AM
You're quite right.

Thanks very much!

monovich
04-21-2010, 10:46 AM
man... there are so many interesting possibilities with DP nodes. it boggles my mind.

StereoMike
04-21-2010, 06:10 PM
Please read this thread. It's all in it (with an animated gif at the bottom).
http://www.newtek.com/forums/showthread.php?t=101997

And this one:
http://www.newtek.com/forums/showthread.php?t=99481