View Full Version : Cannot close polygon right way - what is wrong?

02-18-2010, 05:02 AM
Hi Guys
please take a look on my mesh. What should I do to make it clean.
It should be in grey without that empty triangles.:help:

02-18-2010, 05:31 AM
the quick and dirty way is to shift t it but you've got way too many points in these n-gons imo. So if its an EPS or AI file you've imported you can try re-importing it with the curve division level set to standard or even rough or maybe work directly on the n-gons and try the reduce points command with the point reduction threshold setting to low or medium (construct tab) !

02-18-2010, 06:38 AM
you could also triple everything, then merge it. sometimes that gets rid of it, if it doesn't, you can use the knife tool a few times then triple it. I agree that those are way to many ponts.

02-18-2010, 06:48 AM
You need to add some splits, Modeler doesn't like single polys made with loads of points.

02-18-2010, 06:58 AM
Have you tried rendering it?

It could just be a display glitch (which is common in modeler) which wont show up when rendered.

02-18-2010, 07:52 AM
Thank you a lot! I need to make it manually, something is worng with these lines and I do not know.