kyuzo
New member
I was trying to figure out just what exactly Inset Scale and Polygon Step rate did on the bottom tab of the Rounder tools numeric panel. The online docs don't seem to cover any of the bottom three tabs.
I found the information I needed in my LW9 PDF manual. I can't imagine this has been omitted on purpose, so it should probably be reinstated to the current docs.
Apologies to BeeVee if this messes up your massive conversion of the current docs to offline versions...
Derek
I found the information I needed in my LW9 PDF manual. I can't imagine this has been omitted on purpose, so it should probably be reinstated to the current docs.
Apologies to BeeVee if this messes up your massive conversion of the current docs to offline versions...
Derek