Motion Designer Wind Cycle/Gust Property Problems

[Jesse]

Has anybody else run into this problem- where you set a new Wind Cycle length or Gust length in MD, hit continue, and then find that Motion Designer has reset these values to default? Is there a way to take care of this, or have I forgotten something obvious? Any help would be appreciated, I'm at my wit's end here.

[Rich]

I have found that sometimes while using MD that if I don't hit enter or press the tab key after entering a number into the text fields that it doesn't keep that number when I close the MD Property window.

[Jesse]

Wow, it worked. Thanks Rich. It's always the small stuff that gets to me.

[Jesse]

I'd been hitting enter repeatedly, but with no success. Tab however, seems to work, for whatever reason. Either way. Good times.

[dablan]

MD is pretty cool -
someone else earlier posted some cool water type scenes, but I can't find that post at the moment.

I made this in a matter of minutes -
http://www.3dgarage.com/testflash.swf

And you can download this scene and check it out yourself at
http://www.3dgarage.com/3dgarage.zip

Just go to the scene tab, once the scene is loaded, and open the MD Controller - push start.