ralstonvaz
07-05-2003, 10:33 AM
Good day all,
I am fairly new to Lightwave and am using version 7. I recently installed a GFroce FX 5200 graphics card in my PC that supports dual VGA. I am using it just fine with two monitors but have not been able to figure out how to best use it in Lightwave Modeler.
I am able to move interfaces such as the surface editor and preset shelf to the second monitor with just a click and drag. What I would like to do is move some of the viewports over to the secondary monitor and maximize the Perspective view on the primary monitor. I would also like to move the main tool bar to the secondary monitor.
If there is a way to achieve this, I'm sure one of you on this forum knows how.
Thanks,
ralstonvaz
I am fairly new to Lightwave and am using version 7. I recently installed a GFroce FX 5200 graphics card in my PC that supports dual VGA. I am using it just fine with two monitors but have not been able to figure out how to best use it in Lightwave Modeler.
I am able to move interfaces such as the surface editor and preset shelf to the second monitor with just a click and drag. What I would like to do is move some of the viewports over to the secondary monitor and maximize the Perspective view on the primary monitor. I would also like to move the main tool bar to the secondary monitor.
If there is a way to achieve this, I'm sure one of you on this forum knows how.
Thanks,
ralstonvaz