LWCAD 2.1 bug?

[hrgiger]

I was just using the wall tool in LWCAD 2.1 and there seems to be an issue with the wall not being visible when attempting to add to a current wall. Can anyone else confirm this? I wrote to Victor at WTools to let him know about this... See the attached pic.

[lab2]

Yes, I have the same problem with LWCAD 2.0

[colkai]

Hmm, nope, I don't have any such problems at all.

[W-Tools]

I was just using the wall tool in LWCAD 2.1 and there seems to be an issue with the wall not being visible when attempting to add to a current wall. Can anyone else confirm this? I wrote to Victor at WTools to let him know about this... See the attached pic.

Hi,
Now when I see your problem on the picture I think it might be not a bug.

You should try two things:
First freeze all existing geometry into zero plane. If you are XY viewport then just set z=0.

And second check existing walls with "Analyze Curves" tool. Switch to show loop disconnection. And fix every disconnection.

If wall curve boolean still gives you that wrong result, then just switch curve boolean off. And delete redundant line pieces with Trim tool.

I hope this help.
Viktor,

[FredyN]

*****, in LW 9.0 (LWCAD 2.1) is it OK
***** - in LW 9.0 is it OK

Edited by moderators:
LightWave v9.2 is covered by NDA and should only be discussed in the Open Beta forums.