Lathe

[Neural Riptide]

When using the "lathe" command in and Lscript, you have to put in the values: axis, nsides, center, end, start

Axis and Center seem to be only able to have a single value in them. so, for instance, it appears that you can only enter the numeric value of one axis for the Center part.

Is this what it appears as? or is there a way to enter all three XYZ for the center value?

Also, there doesn't appear to be an option for entering an "offset" to the lathe action (like the main tool has). Does it exist?

[zyhsu]

Hi!

I think you can try the commandInput() section of the user reference menu, where you can use most of the lightwave command inside of modeler and layout!you can use "save command list" to check what command you can use!