Need modeler help.

[monkey-vic]

I need a little help? When I'm working in modeler and I save my work when I try to open it, it says that the file is read-only so these is getting me some trouble to continue with my work. I even try to change it by clicking the right mouse botton and press on properties but there is nothing to fix. If someone could help me it will be great. Thanks

[Captain Obvious]

Use incremental save (shift-S). It might work.

[Silkrooster]

Check the properties of the folder that you are saving to. If the folder is set to read only then the files in it should be read only. Normally you don't see this problem unless the files were on a cd. As all files on a cd are read only.
Silk

[monkey-vic]

Thanks for your sugestions but I already did what you all said. When I save the file I save it on my desktop, and when I open the object on modeler and I try to continue working on it a message comes out and it says that the object is read-only. Also, the icon that appear on the object is the icon from WordPad and that's just wird. I don't know what else to do.