Module Configuration - Saving and Loading

[RandyM]

Ok I believe this part of VT3 is buggy!

I entered all my song pages into DDR1 and DDR2.. i have about 7 DDRs, vision, switcher etc opened as well.

As I'm adding things for Sunday I continually right click and select SAVE MODULE configuration. I resave over the same name which is "Sunday".

System crashed, so I Ctrl VT and killed WinrTME, then reloaded VT
Went to load module SUNDAY.... it was an old one. Am I to guess that the saving really only takes place if you close down vt 3 and then reload?

YES if it doesn't crash and you reload the module you just saved.. it gets even wackier... nothing much really shows up and everything is messed. then if you load the same module AGAIN, it fixes it.

So two problems.... trying to load a module you just saved... messes up unless you load it a second time...
and #2 when it crashes AFTER you saved a module configuration. it pull up an old saved configuration.

anyone?

[podro]

i've had at least a dozen times over this year, where vt has locked up, and the ddr's were messed up with song lyrics, and even the ddr's renamed to different names.

the best thing i've figured to do, it once you've got your cofiguration set, do a clean exit of the vt before the service starts...check that, some time before the service starts and open it back up, should be fine if you need to crash out of the vt during the service...


it's something that kind of irks me...but nothing to do...