lasco
12-17-2003, 04:50 AM
Hi,
anyone knows if there is a way we can freeze curves
in a "1 point for 1 point" level ???
Currently the Modeler's prefs allows us just a "Coarse" level
that already adds much points to the freezed curves.
That is quite annoying for me because I use much the drill command
with imported DXF curves that have a correct number of points
when not freezed but far too heavy when freezed.
Of course the trouble is that even if you drill or boolean with a
non-freezed curve the result with be what you'd get with a freezed one.
For the moment the only solution I have is to select all my curves,
one by one and point after point, convert all in 2 points polys before drilling :
what a waste of time !!!!
So… am I that stupid as did'nt see a faster solution before (and so : which one ?)
or is it one more basic setting that Lightwave misses (in that case I'll immediatly
re-write this message in the features requests forum…)
anyone knows if there is a way we can freeze curves
in a "1 point for 1 point" level ???
Currently the Modeler's prefs allows us just a "Coarse" level
that already adds much points to the freezed curves.
That is quite annoying for me because I use much the drill command
with imported DXF curves that have a correct number of points
when not freezed but far too heavy when freezed.
Of course the trouble is that even if you drill or boolean with a
non-freezed curve the result with be what you'd get with a freezed one.
For the moment the only solution I have is to select all my curves,
one by one and point after point, convert all in 2 points polys before drilling :
what a waste of time !!!!
So… am I that stupid as did'nt see a faster solution before (and so : which one ?)
or is it one more basic setting that Lightwave misses (in that case I'll immediatly
re-write this message in the features requests forum…)