NO Video Signal - Possible Driver Lockup

[Blondepower]

I just installed my VT3 on a new system

Asus PCDLU - dual xeon 2.8
1gb Ram
Adaptec 3940

I am running Xp with SP1 and all updates.

When I launch VT3 software and try to load up a VT-Vision. I get the error No Video Signal- Possible Driver Lock up.

I currently dont have sources attached to the back of the card.


I took the card to a much slower P4 system and it seems to work with out any connections, but much slower.

Does anyone have any sugestions?

Thanks

Blonde

[ion]

I have had the same problem then i uninstalled VT[3] and reinstalled it worked fine for few hours then it hung and wouldnt switch back on again.

I went back to vt2 for the timebeing till we finish our project then try vt3 again

[Jim_C]

Did you do a full wipe/reformat install of T3? or uninstall T2 then install T3?

Try searching this forum and maybe this one
http://www.videotoasternt.com/forums/
for 'possible driver' or etc. Its discussed much, but solutions are slipping me.

jim

[ion]

I did an vt[2] uninstall and then reinstall vt[3] i think i need to do a clean wipe and then install vt[3]

Thanks, will check the toasternt forums.