What replaced drectangle in LWCAD 3.5?

[aidenvfx]

I am just going through some old training on the LWCAD site and in the video they use drectangle to cut through the 2nd floor that has a stair case going to it. I am wondering how that would best be accomplished in LWCAD 3.5 since 3.5 does not seem to have drectangle.

[RonGC]

You can use box or box 3p with sub turned on does the same thing.

Ron

[aidenvfx]

thanks

[prometheus]

You can use box or box 3p with sub turned on does the same thing.

Ron

Just curious, isn´t that a little wrong, sub turned on would just cut out the whole section, not slicing?

I think that it is the add mode turned on seems that seems to have replaced it.

Michael

[hrgiger]

Just curious, isn´t that a little wrong, sub turned on would just cut out the whole section, not slicing?

I think that it is the add mode turned on seems that seems to have replaced it.

Michael

No, he's referring to the tutorial where a hole is made in the floor so that the staircase can lead up to the second floor. Subtract is used because it allows you to drag a hole in the floor where you want it.

[prometheus]

No, he's referring to the tutorial where a hole is made in the floor so that the staircase can lead up to the second floor. Subtract is used because it allows you to drag a hole in the floor where you want it.

sorry..my mistake, I was somhow mistaken it for that he would like to do a slice, but of course not, otherwise the add mode is valid for slicing a construction line.

Michael