I hope I didn't mess up, with my stripe set....

[kleima]

I am upgrading to a new motherboard, and I did a clean install of W2K (with format).
Now all the SCSI drives show up as individual drives rather than the two stripes sets that they were before. I hope I didn't mess up, because I need the info on the drives. Can I make them into to stripe sets again without losing all my data?
Please tell me I didn't just hose all my data....

[kleima]

Actually, Windows explorer shows them each with a separate drive letter. But, the Disk Management utility shows all the drives from the one stripe set all with one drive letter, and all the drives from the other stripe set with another letter.

[kleima]

Weird. I added another SCSI controller, and connected the external RAID, and when I rebooted, the internal stripes (that I was referring to above) showed up as the two original stripe sets with all data intact! :)