Setting up tight shot as input 2

[d912mv]

Hi.

I have the Tricaster Pro and one camera connected to input 1. I have set up input 1 as a tight shot using a virtual set. I would like to configure input 2 as a wide shot, again using the same camera that is connected to input 2.

Is this possible? If so, how do i do this? At the moment the only way i can go to a wide shot is selecting the relevant effect in the virtual studio options although the change is then instant.

Thanks
Dan

[SBowie]

The only way to perform this with an SD model TriCaster is to split the source upstream of the system, and supply it to two inputs.

Just as a sidenote - TCXD300 allows this (without using a physical input to duplicate the signal) by means of it's "Virtual Inputs".

[ZachSchuster]

Just curious... are you just wanting to cut from a close up to a wide shot of the set? If so, just do that live on input 1 by clicking from close up to wide on your virtual set angle options.

or maybe I'm not fully understanding what you're trying to accomplish.

[SBowie]

If so, just do that live on input 1 by clicking from close up to wide on your virtual set angle options.I think our friend is already doing that, unless I misunderstood: "At the moment the only way i can go to a wide shot is selecting the relevant effect in the virtual studio options although the change is then instant." I drew from that that he wants to use a transition.